Оригинальное название:
Усилитель мощности Crown Audio XTi 1002 с ремешками (10 штук в упаковке) и (2) кабелем
Output Power:
700W @ 2 Ohms Stereo (per Channel)
500W @ 4 Ohms Stereo (per
Damping Factor:
20Hz to 1kHz > 500
Input Sensitivity:
1.4Vrms
Input Impedance:
20k Ohms (Balanced)
10 kOhms (Unbalanced)
Gain:
32.9dB @ 1kHz, 8 Ohm Rated Output
Frequency Response:
(at 1 watt, 20Hz - 20kHz) +0dB, -1dB
Signal-to-Noise Ratio:
XTi1002/2002/4002: 100dB (A weighted)
Total Harmonic Distortion (THD):
< 0.5%
Connections:
Input Connectors: XLR, one per channel
Link/Out Connector: Loop-thru signal from in, one per channel.
Output Connectors: Two Neutrik Speakon NL4M, connects to HiQnet network.
Controls Front Panel:
Level: Two front-panel rotary level controls, one for each channel
Power Switch: On/Off switch applies AC
Indicators:
Signal Indicator: Green LED, one per channel, illuminates when a very low-level signal is present at input (ma, illuminates when the amplifier is ready to produce audio.
Cl, turns on at the threshold of audible distortion
Temp Indicat, illuminates under excessive temperature conditions
Power Ind
Cooling:
Proportional speed fan with front-to-rear airflow.
Power Consumption:
6.8A; no more than 38W at idle
Power Requirements:
100 VAC, 120 VAC, 220-240 VAC 50/60 Hz
Dimensions:
19 x 3.5 x 12.25" (48.26 x 8.89 x 31.11cm)
Specialties:
DSP Includes EQ, Crossover Filters, Delay, and Subharmonic Synthesizer
Protection for Short Circuits, Overloads, and Overheating